If that still gets nothing, try the 3-second push to switch from mobo control (which you don't have) to pushbutton control.įor your fans, at first you will have no speed control for them. So if no lights are on, try the long press first to turn them on. Turn on / Turn off the light : Press Led button for 6s (After the motherboard's software detected the fans) Motherboard control : Press Led button for 3s. NOTE the instructions in the case manual and on its web pageĬhange lighting mode : Press Led button for 1s With no connection to a mobo ARGB header, the board allows you to change the light displays by the pushbutton on top. It gets a fan speed control signal from the CHA_FAN1/WP header and shares it out to all the fan motors on the lower-edge ports. That control board gets power for all your fan motors and their lights from the PSU connection. Below that the 2-pin port undoubtedly is connected to the pushbutton lighting control on the top front of your case. Do not use the 3-pin fan header called CHA_FAN2 at bottom centre, (item 15) - that header does NOT provide the PWM signal your board requires. 6-7, and connect that to the CHA_FAN1/WP port (item 20) to the rear of mid-board. For that I expect that the 4-hole connector with only two wires in your first photo is already connected to this control board Port. The lower 4-pin labelled Gnd O-In Gnd P-IN is likely the input for a PWM speed control signal from a mobo fan header. The top port labelled 12V Gnd Gnd 5V is the power input from the PSU. On the right-hand edge are two four-pin ports and a 2-pin one. The port above that, and the four across the top, are the output ports for the lighting cables from each fan.Īcross the bottom edge are five 4-pin ports that are the outputs to the MOTOR cables from each fan. Since you do not have one of those on your mobo, you can ignore that completely. The lower one labelled G (blank) D 5V is for input of an ARGB control signal set from the mobo header IF you have one, and for that you use the cable in your third photo. On the left of the board there are two ports. That controller board centralizes this for the case fans, and provides ways to input signals for those functions from the mobo headers. Each has its own separate cable to provide power and control from different sources. ARGB fans really are two devices in one unit- a motor for the fan, and a set of lights in the frame. Look at the photo of the controller board. My question is can I get the lights to at least come in even if they wont change color with this mobo? If so where do I connect them. I tried hooking these to the 3 pin and 4 pin connectors on the mobo but still no lights. There is one three pin connector labeled VDG In and one four pin connector. The controller on the inside of the case came preconnected so I connected the controller to the PSU and there are two connectors for the lights. I would think the lights would light up without these components since the fans are spinning but disclosing just in case. Just for full disclosure I don't have a HD or memory installed yet. Montech Air X ARBG Case - has an LED Switch on top and a controller inside that all of the fans and lights plug into The fans are spinning so I know they are getting power. I am building a budget gaming pc for my son and I'm having issues getting the case fans to light up.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |